Disk Recoup 2.1 is a Disk Management product from quetek.com, get 4 Stars SoftSea Rating, Disk Recoup is a disk copy utility for faulty hard drives that are not totally dead. It can clone hard drives with bad media spots (sectors) and other non-critical hardware faults that may cause other data recovery utilities to hang. Disk Recoup uses hardware-level disk commands and intelligent algorithms to copy the raw data from the source drive to another hard drive. Disk Recoup accesses the source drive strictly in read-only mode and presents no risk to the source drive except for normal wear and tear.
For Disk Recoup to work, the drive must still be detected by the computer BIOS at boot time and respond to basic disk commands.
In the best-case scenarios, the destination drive will be accessible normally in Windows Explorer after the copy operation is complete and the computer is rebooted. In other scenarios, the drive is not directly accessible but the files and folders it contains can be recovered using a file recovery utility such as File Scavenger. See "What is copied".
While copying a faulty hard drive, Disk Recoup and even Windows may hang on reading a bad spot on disk. That usually requires a reboot. When it is restarted, Disk Recoup will intelligently avoid the bad spot and continue to copy other parts of the hard drive. A badly damaged drive may require a few reboots. Eventually Disk Recoup will copy all readable data.
Disk Recoup can be used in the following cases:
A hard drive contains many bad media spots (sectors) which cause other data recovery utilities to hang.
A hard drive is accessible after the computer is booted up but may go offline later without warning.
A hard drive is detected by the computer BIOS at boot time but may cause the computer to hang later.
The drive electronics have partially failed and only respond to basic disk commands.
Disk Recoup does not work in the following cases:
A hard drive has a mechanical failure and does not spin up.
The drive electronics have totally failed and do not respond to any disk commands.
A hard drive is not detected by the BIOS when the computer is turned on.
In other words, Disk Recoup can copy a faulty hard drive that is not totally dead. A dead hard drive must be sent to a clean room facility where it is read with special hardware equipment. Sometimes faulty components must be replaced. Fortunately, a large majority of faulty hard drives can be copied. See "Determine the status of a hard drive".
Disk Recoup is not required when a hard drive has no hardware faults but data is not accessible in Windows Explorer due to corruption or accidental deletion of partitions. In this case use a file recovery utility such as File Scavenger to recover files.
Disk Recoup supports the following types of storage devices, listed in the order of Disk Recoup's impactfulness:
IDE drives and SATA drives.
SCSI, SAS and USB drives.
Zip drives, CD, DVD, memory cards (such as Memory Stick, Compact Flash, MMC, SD, xD, etc.), and other removable devices. The license of this file & disk software is Free Trial Software, the price is $95.00, you can free download and get a free trial before you buy. If you want to get a full or nolimited version of Disk Recoup, you can buy this file & disk software.